©Copyright Task Force Tips LLC 2017-2018
LIY-210 September 17, 2018 Rev01
12
4.3 QUICK CONNECT INSTALLATION
A rotational lock is included on quick connect couplings. The locking pin also holds the coupling up and out of the way while orienting
the monitor to engage the internal ear into the slot on the adaptor. Hold the pin out, push the coupling up and the release pin before
installing monitor on the adaptor. Once the monitor is properly aligned on the adaptor, hold the pin out while sliding the coupling
down to the adaptor. Rotate the coupling until it is tight. The coupling may become suffi ciently tight before reaching the next detent
position. It is not necessary to over tighten the coupling if the pull pin is between detent positions. Do not use the pull pin as a lever
to tighten or loosen the coupling.
2 1/2" NH Coupling
Inlet With Lock
Internal Ear On EF1 RC Engages This Slot On The Adapter
To Give Rotational Alignment.
Straight Ahead Reference Mark
Important: Install So Straight Ahead Reference Mark
Is Facing Desired Direction. See Figure 4.2b.
Flanged Inlet Adapter
Female Threaded
Inlet Adapter
Y1165
®
SERIAL# www
.tft.com-Y
123456
219-462-6161 • www
.tft.com • MADE IN USA
#
MODEL#
Fig 4.3
Inlet Adapter and Straight Ahead Reference Mark
4.2.1 TRAVEL STOPS
Vertical Travel Stops are cast into the elbow of the monitor. Instructions on how to install horizontal travel stops are shown below.
1. Rotate horizontal travel stop 90° one direction
and insert into coupling track.
2. Rotate back to original position ensuring the letter
is located at the top of the travel stop.
3. Rotate the monitor to the desired position, position
the travel stop next to the Monitor's Stop Ear.
4. Tighten set screws to lock the travel stop position.
Y1165
®
SERIAL# www
.tft.com-Y
123456
219-462-6161 • www
.tft.com • MADE IN USA
#
MODEL#
Fig 4.2.1
Travel Stops