10
- (Fig.IX)
Insert the belly bar from above into the frame tubes. Secure
it by moving the clamping lever
(17)
. By pressing the red buttons
(18)
at the left and right side you can swivel it to different positions.
- (Fig.X)
You can set the height of the push bar by pressing the two
adjustment joints
(23)
.
- (Fig.XI)
The handbrake is a walking and parking brake at the same
time. To activate the parking brake, you must pull the brake lever
(20)
fully tight and completely close the red parking lever
(21)
, so
that the brake lever
(20)
remains tightened to the maximum and the
brake is permanently blocked. If the braking effect starts to weaken,
you can carry out a fine adjustment. To do so, turn the adjusting
screw
(22)
on the brake grip anti-clockwise and check the braking
effect again.
- (Fig.XII)
To close the Twin Trail, you must push both locks
(23)
upwards. They remain automatically open. Then you can move the
push bar
(24
) in forward direction. The frame construction
automatically closes.
- (Fig.XIII)
Close the transport lock
(25)
on the frame to ensure that
the Joggster Trail does not accidentally open up again.
- (Fig.XIV)
If you are using the Twin Trail in cross-country terrain, please
fasten the enclosed retention strap on the rear axle. Then pull the
side with the elastic band over your wrist.
