3. Mark the holes position and align the wire coming from the wall in
the hole beside the connectors.
4. Drill two holes and insert the plastic anchors carefully into the holes
until they are flush with the wall.
5. Fasten the thermostat to securely the wall with the two screws.
Connecting the Wires
1. Connect the system wires to the terminals according to the wiring
diagram shown in the section “WIRING DIAGRAM”.
2. Push the wires back into the wall, seal the hole in the wall and
replace the cover over the connectors.
Wiring Diagram
The thermostat can be used with any single stage Heating or Cooling
system. Inside the thermostat, you will find three terminals which are
labeled as COM, NO and NC. It is a typical single pole, double throw
(SPDT) contact. Connect your Heating/Cooling system to the
terminal COM and NO (or NC, depends on the type of Heating/
Cooling system). In most case COM and NO are used.
7
COM
NO
NC
NO
COM
NC
