Wire Labeling
1. Disconnect and identify each wire.
2. You may wish to tape the wires to the wall to keep them from
slipping through the hole in the wall. If the hole in the wall is larger
than necessary, fill it in order to prevent hot or cold air from
penetrating the thermostat. By doing this, the thermostat will
operate correctly.
Choosing a Location
Note: for a new installation, choose a mounting location about five
feet (1.5 meters) above the floor in an area with good air circulation
and away from:
1. Areas or corners where there is no air circulation.
2. Air ducts.
3. Radiant heat from the sun or appliances.
4. Concealed pipes and chimneys.
Mounting
Mounting the thermostat onto the wall.
1. Completely remove the front housing of the thermostat.
5
