25
24
ICON
– Design Radio-controlled alarm clock
ICON
– Design Radio-controlled alarm clock
Your radio clock receives the signal, converts it and always shows the exact time. The adjustment to Day-
light Saving Time (summer/winter time) is automatic. The reception quality depends mainly on geographic
location. In Daylight Saving Time DST is shown on the display. Normally there should be no reception prob-
lems within a 1,500 km radius around Frankfurt.
Therefore, please note the following steps:
• The recommended distance to any interfering sources like computer screens or TV sets is at least 1.5 -
2 meters.
• Within concrete walls (reinforced with steel) such as basements, the received signal is naturally weak-
ened. In extreme cases, please place the unit close to a window to improve reception.
• During night-time, the atmospheric interference is usually less severe and reception is possible in most
cases. A single daily reception is adequate to keep the accuracy deviation under 1 second.
7. Operation
7.1 Manual settings
•
Important:
The device cannot be operated during the DCF time-signal reception.
• Press and hold the
UP
or
DOWN
button in setting mode for fast mode.
• The device will automatically quit the setting mode if no button is pressed for 20 seconds.
• The DCF reception always takes place at 2:00 and 3:00 o'clock in the morning. If the reception is not suc-
cessfully received at 3:00 o'clock, further attempts will be taken until 5:00 o'clock.
• To avoid interference, the weak backlight turns on automatically during the reception of the radio controlled
clock.
• There are 3 different reception states:
Symbol flashing - reception is active
Symbol solid - reception is very good
no symbol - no reception/time was set manual
• If the clock cannot detect the DCF-signal (e.g. due to interference, transmitting distance, etc.), the time
can be set manually. The DCF reception symbol disappears and the clock will then work as a normal
quartz clock (see: Manual settings).
Note on radio-controlled time
The time base for the radio-controlled time is a caesium atomic clock operated by the Physikalisch Tech-
nische Bundesanstalt based in Braunschweig (Brunswick), Germany. It has a time deviation of less than
one second in one million years. The time is coded and transmitted from Mainflingen near Frankfurt via
the frequency signal DCF-77 (77.5 kHz) and has a transmitting range of approximately 1,500 km.
TFA_No. 60.2543_Anleit_02_20 27.02.2020 17:28 Uhr Seite 13
