Different Speed mode
Different Speed mode is indicated by "DIF". Push mode key (right key) to reach this function.
The lower display will show the different speed between the current speed and Ibe average
speed (+/-).
(Note: The Different speed has a range of -150.0 to 150.0 km/h (or mile/h)
and a rest value of 0.0)
Scan function
Scan function mode is indicated by "SCAN". Push mode key (right key) to reach this function
after Different Speed function. SCAN icon will show and the lower display will show values of
ODO, DIS, TM, CLK, AVS, MXS and DIF in sequence change every 6 seconds.
Trouble Shooting
TROUBLE POSSIBLE
CAUSE
Speedometer always reads
Improper magnet/sensor alignment, check
zero when cycling.
magnet/sensor mounting.
Slow display response.
The cyclocomputer has been operating at a
temperature below 0°C, it returns to normal
state when temperature rises.
LCD is black.
The cyclocomputer has been exposed to the
sun for a long time, place it in the shade to
return to normal state.
Display readout fades.
Poor battery contacts or dead battery, check
battery installation or replace battery.
Important note
Before starting a new trip, the user can clear the values of the previous trip by pushing the
MODE switch until the DIS icon is shown. Push down the Mode switch (left switch) and hold
until the DIS value is reset to zero. The value of AVS at this stage can be ignored. As the
user embark on a new cycling trip, all new values of DIS, DIP, TM, AVS and MXS will be
calculated and displayed.
Safety Precautions
- PIease dispose the BATTERY UNIT in an environmentally friendly manner in accordance
with the relevant legislation.
- Replace only with the same or equivalent type of battery recommended by the
manufacturer.
- Not to be exposed dripping or splashing.
Содержание 42.5003
Страница 3: ......