2. DISPLAY OVERVIEW
Note: x’s shown in the figures in this manual will be numeric readings on
the display.
LCD indicates:
•
Mode: SCAN mode (with detected marker type shown), or single mark-
er mode (i.e. Power, Water, etc.) (See Figures 24 & 25)
•
Numeric indication and bar graph
(See Figure 3)
•
Gain Setting (See Figure 23)
•
Volume adjustment for speaker res-
ponse (See Figures 4 - 7)
•
Estimated battery life in hours and low
battery warning (See Figure 2)
•
Time out feature with disable
(See Figures 16 - 20)
ON/OFF Switch
When the EML100 is turned on, the display will first show the firmware version
and then the estimated battery life remaining. (See Figure 2) After the Power-
On Sequence, the unit will default to the mode and settings that were used last.
For example, if the unit was last used to locate Gas markers with the Volume
set on Low, it will return to the same settings. (See Figure 3)
Menu Key
Note: The EML 100 is active as soon as it is turned on and completes the
Power-On Sequence. The bottom line of text on the display shows available
options when using the MENU Key.
Press the MENU key to cycle through the following 4 sub-menus :
Volume Control
Use the Up or Down Arrow keys to select Off, Low, Medium, or High and use
the EXITkey to exit the MENU screen. (See Figures 4 - 7)
Pressing the MENU Key again will display the MODE Select menu.
5
Fig. 2 - Version & Battery
Fig. 3 - Sample Display
Fig. 1 - EML 100 Display Panel
Fig. 5 - Low Vol
Fig. 6 - Medium Vol
Fig. 7 - High Vol
Fig. 4 - Vol Off
