Greenlee / A Textron Company
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
HK520 Hydraulic Cable Cutter
Operation
1.
Lift the head latch to open the cutter.
2.
Place the material to be cut between the jaws.
3.
Close the head latch completely.
4.
Align the material at a 90
°
angle to the blades.
5.
Pump the pump handle to advance the blade.
6.
When the cut is complete, press the release lever to
retract the blade.
Note: Do not continue to advance the blade after the cut
is finished. This could cause the cable cutter to jam.
Cutting
Head
Cutting Blade
Release Lever
Head Latch
Pump Handle
• Do not cut cable under tension.
• This tool is intended for two-handed operation.
Maintain a firm grip on both handles during
operation.
Failure to observe these warnings could result in
severe injury or death.
Keep hands and fingers away from
closing blades.
Electrical Shock Hazard: This tool
is not insulated. Use protective
equipment when utilizing this unit
near energized electrical lines.
Failure to observe this warning
could result in severe injury or
death.
• Inspect the tool before use. Replace any worn or
damaged parts. A damaged or improperly
assembled tool can malfunction, injuring nearby
personnel.
• Do not perform any service or maintenance other
than as described in this manual. Injury or damage
to the tool may result.
• Use this tool for the manufacturer’s intended
purpose only. Use other than that which is
described in this manual could result in injury or
property damage.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection can
result in serious eye injury from
flying debris or hydraulic oil.
