EK50ML Battery-powered Crimping Tool
Greenlee / A Textron Company
10
Problem
Possible Cause
Probable Remedy
Tool is inoperative.
Continuous use causes tool to become
too hot and automatically switch off.
Allow approximately 3 to 5 minutes of
time to cool down.
Dirt, contaminants, etc., in jaw area
of tool.
Clean tool.
Tool components worn or damaged.
Return tool to a Greenlee Authorized
Service Center.
Motor is inoperative.
Low or uncharged battery.
Try known charged battery. Inoperative
battery may be discharged or may have
reached life expectancy.
Broken switch components.
Return tool to a Greenlee Authorized
Service Center.
LED glows for 20 seconds.
Battery charge low.
Charge or replace battery.
Note: For Warranty Service or Repair, contact Greenlee customer service at 800-435-0786.
Troubleshooting
Before You Begin
1. Make sure that the battery is charged. Recheck
the battery after several minutes to make sure the
battery is holding its charge.
2. Use a
nonflammable
contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and tool.
3. Reinstall the battery and check the tool again.
www.calcert.com
1.800.544.2843
0
5
10
15
20
25
30
