Textron 614212 2010, Руководство пользователя и сервисное руководство

Страница: 32 / 58

OPERATION AND SERVICE INFORMATION
Page 22
Owner’s Manual and Service Guide
Read all of Manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Dangers and Warnings
LUBRICATION
Do not use more than three (3) pumps of grease in any
grease fitting at any one time. Excess grease may cause
grease seals to fail or grease migration into areas that
could damage components.
Putting more than three pumps of grease in a grease fit-
ting could damage grease seals and cause premature
bearing failure (Ref Fig. 30 on page - 22).
SPARK PLUG
Tool List Qty. Required
Spark plug socket, 13/16", 1/2" drive........................... 1
Ratchet, 1/2" drive ....................................................... 1
Plug gauge, wire type .................................................. 1
Anti-seize compound ................................................ AR
Torque wrench, 1/2" drive, ft. lbs. ................................ 1
Use care not to over-tighten the plug. Over-tightening
can cause damage to the aluminum cylinder head
threads.
Remove and inspect the spark plug at intervals indicated
in the Periodic Service Schedule (Ref Fig. 13 on page -
13). Spark plug should be properly gapped (Ref Fig. 31
on page - 22). Tighten to 16 ft. lbs. (22 Nm) torque.
Fig. 31 Gapping the Spark Plug
Fouled spark plug is indicated by a wet, black appear-
ance. This could be caused by a dirty air filter element or
other restrictions in the air intake system. Incorrectly
adjusted valves, spark plug wire which are in poor condi-
tion or poor quality fuel could also contribute to the prob-
lem.
PROLONGED STORAGE
To reduce the possibility of severe injury or
death resulting from a possible explosion:
Do not handle fuel in an area that is not
adequately ventilated. Do not smoke near
the fuel tank or refuel near open flame or
electrical items which could produce a
spark.
Store vehicle in a clean, dry area. Do not
store in same area as a stove, furnace,
water heater, or other appliance that uses a
pilot light or has a device that can create a
spark.
When refueling, inspect the fuel cap for
leaks or breaks that could result in fuel spill-
age.
Always wear safety glasses while refueling
to prevent possible eye injury from gasoline
or gasoline vapor.
Fig. 30 Lubrication Points
Steering
Unit
Ball Joint
on Rack
and Rod
King Pin King Pin
Idler Arm
View From Underside Of Vehicle
Ref Lub 4S
0.7 - 0.8 mm
(.028” - .031”)
Gap
Plug