Textron Motors 409135 I2 846 UTV NA-80, Руководство по обслуживанию

Страница: 36 / 62

36 SHB MPE850 Rev A | 409135 |
1
3
2
4
8.3 Changing engine oil and oil filter
The engine oil will be pumped out in two stages.
► Warm up the engine. (See chapter 4.2
Operation during the break-in period.)
► Turn off the engine.
CAUTION! Scalding caused by hot engine oil.
Wear protective gloves.
► Unscrew the oil dipstick
1
from the oil
tank.
Draining engine oil
► Insert the suction hose of the oil suction
pump through the opening of the oil dipstick
2
until the hose reaches the oil tank
bottom
3
and pump out as much as
possible engine oil from oil tank.
or
The following procedure is the practice with a Textron Motors oil tank. However, the oil tank is not always in
scope of supply of the engine. If the vehicle equipment is different, observe strictly the vehicle manufacturer's
documentation.
► Place the drain tray under and unscrew the
oil drain plug
4
at oil tank.
► Replace the seal.
► Screw in the oil drain plug.
Tightening torque:
18 Nm +2 Nm [13.3 lbf ft +1.5 lbf ft]
8 Service tasks in the workshop
8.3 Changing engine oil and oil filter