SPB
www.texlabel.eu [email protected] +39 0444 287002
31
For care labels, we recommend setting the print speed in the "Options" tab to 50.80 mm/sec, while the
value to be set for black level strength varies depending on the material used as a print media.
In the last page, there is an example showing the intensity values to be set according to the material to be
printed on.
In general, the higher the Print Speed, lower is the print quality.
Intensity is the temperature at which the print head thermally transfers the ink (also called Ribbon, foil,
film) to the print ribbon.
The higher the intensity, the more marked the printing is.
All materials are available at TEXLABEL. From wax, wax/resin to resin. Ribbons with a wide range of sizes
and colors according to your needs, ready for delivery and without minimum order.
N. B. Too much intensity leads to 3 unpleasant effects: ink can deburr, the label can stick to the ribbon
instead of leaking out of the printer, and the print head wears out faster.
The less the intensity, the more faded the writing is.
The right intensity must be found according to the result you want to obtain (large, small inscriptions,
drawings, logos, geometric shapes, etc.).
We recommend that you try to print with low intensity and then increase it until you get a satisfactory
result (label printed with good sharpness have no smearing or sticking problems)
In this page
http://www.texlabel.eu/wp/ribbons-labels-en/
there are four types of ribbons (Satin Ribbons,
Polyester Ribbons, Nylon/Polyamide Ribbons, Polyurethane Ribbons). In each section you can see some
examples of composition labels printed by us, and at the bottom of each label you can read the code of the
ribbon.
Contact
TEXLABEL
for
FULL SAMPLE BROCHURE
.