ComGSM Module
Installation Manual
4
INS315
2.
Install the module in the required location using suitable fixings.
3.
Route the other end of the harness lead into the control panel housing.
DO NOT CONNECT at this point.
4.
Connect the GSM antenna to the antenna connector on the module
(
)
and site
the antenna as high as possible.
5.
Unlock the SIM socket by sliding the locking tab downwards. Insert the SIM card
into the holder with the chamfered corner to the top left. Push the holder back
into position and lock the SIM by sliding the locking tab upwards.
The SIM card must be inserted before connecting the
ComGSM
module to
the control panel, and must not be removed until after the power supply to
the
ComGSM
module has been deactivated.
6.
Set the option switches as required, see page 3.
7.
Now connect the harness lead onto the control panel communication port (COM
2 for the
Premier 24
;
COM 1 or 2 for the
Premier 48/88/168/640
).
8.
The module should now be powered and the heartbeat LED
(
) sh
ould be
flashing.
Panel Configuration
Before attempting to use the
ComGSM
module it must be correctly configured as
follows:
1.
Enter “Engineers Programming” mode and select “UDL/Digi Options”, then
select “Com Port Setup”. Ensure Com Port is programmed as “GSM Module”.
2.
Now select the “Digi Options” menu and make sure that “Digi Option 1” is
programmed for “Digi is Enabled”.
3.
Now select “Program Digi” and ensure the following options are programmed for
one of the ARC options:
a)
Protocol: “SMS Messaging”.
b)
Primary No: The number of the recipients mobile telephone.
c)
Secondary No: Secondary mobile telephone number (if required).
d)
Account No: Leave blank.
e)
Dialling Attempts: Program as required.
f)
Report Areas: Program as required.
g)
Reports: Program as required.
h)
Config.: Program as required.
4.
All three status LED’s should now be on, if status LED 3 is dim, this indicates a
low GSM signal level. If the signal level is low, try moving the antenna to improve
the reception.
