19
Figure L, 2.
Neutral is between 2 and 1.
Figure L, 2.
Always make sure to select the proper gear before activating the clutch (figure 4,b).
Adjusting the depth skid
The depth skid can be adjusted for tilling five different depths. The deeper the depth skid sits in the
soil, the deeper the tilling blades will work and the slower the machine will advance. Using the right
tilling depth will lighten your workload. The depth skid will need to be adjusted to suit the ground
conditions, and we recommend that you make several attempts to see how deep the depth skid
should be before deciding which setting works best.
To adjust the depth skid, pull it backwards and up until it reaches the preferred height.
Position the depth skid vertically and lower it into one of the notches.
The depth skid can be adjusted to suit various tilling depths. The deeper into the ground the depth
skid goes, the deeper the tiller will work. The right setting depends on the ground conditions.
Figure F/G.
Adjusting the support wheels
The rear wheel set is mounted on the machine. This can be adjusted to the required height by
pushing the pedal forward with your foot. Raise or lower the tiller until the support wheels are at
the required height. Release the pedal.
Figure K.
Adjusting the steer
The height and angle of the steer can be adjusted. It can be an advantage to adjust the steer to
either left or right during cultivating. Then you can avoid walking in the cultivated soil. Use the
wheel figure L, 1.
Cleaning the tiller
The tiller should be cleaned after use. Use a garden hose to wash off soil and dirt. Remove any
grass, etc. from the rotor shaft. The chassis number should only be cleaned with a damp cloth,
otherwise there is a risk that it might be erased. Avoid using a high-pressure washer during
cleaning.
Maintaining the chain housing
The chain housing is lubricated with TEXACO Multifak EP0 grease at the factory. This process
does not need to be repeated.
Содержание Vision 700
Страница 4: ...4 ...
