Texas GBV 260, Руководство пользователя

Страница: 16 / 17

16
Trouble Shooting
PROBLEM POSSIBLE CAUSE SOLUTIO
The engine does not
start.
1. No spark.
Check the spark plug. Take off the spark plug,
place the spark plug cap on the spark plug and put
the spark plug on the metal cylinder. Pull the
starter and check if there are sparks on the top of
the spark plug. It there are no sparks repeat the
procedure with a new spark plug.
2. No fuel.
Press the fuel primer. If the problem persists,
contact your local dealer.
3. ”Drowned” engine.
Remove the spark plug and turn the product so
that the spark plug hole faces the ground. Switch
the choke to “RUN” and pull the starter 10-15
times. Clean the spark plug and fit it again. You
might also replace the spark plug.
Pull the starter 3 times with the choke switched to
”RUN”. If the engine does not start, move the
choke to “Choke” and normal starting procedure is
used. If the engine still does not start, repeat the
procedure with a new spark plug.
4. The starter must be pulled
harder than when the machine
was new.
Contact your local dealer.
The engine starts but
does not accelerate. The carburettor should be ad-
justed.
Contact your local dealer.
The engine starts but
can only run on full
power and on half
choke. The carburettor should be ad-
justed, repaired or cleaned.
Contact your local dealer.
The engine does not run
on full power and
smokes heavily. 1. Check the mix of the petrol
and oil.
Use new fuel with the correct mix.
2. The air filter is dirty. Clean or replace.
3. The carburettor should be
adjusted.
Contact your local dealer.
The engine starts, runs
and accelerates but
cannot run idle. The carburettor should be ad-
justed.
Contact your local dealer.
Oil leaks from the ex-
haust. 1. The trimmer is not used on full
power.
Use full power.
2. Check the mix of the petrol
and oil.
Use new fuel and correct two-stroke mix.
3. The carburettor should be
adjusted.
Contact your local dealer.