Texas Instruments UCC27288EVM, Руководство пользователя

Страница: 3 / 19

www.ti.com
Description
3 SLUUCB3 – June 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
Using the UCC27288EVM
2.2 I/O Description
Table 1 details the connection descriptions.
Table 1. Connection Descriptions
Pins Description
VCC V
CC
positive input test point. Powers IC VDD pin, use 6-V to 16-V range.
VDD V
DD
positive input of UCC27288 IC
GND Multiple test points. V
CC
negative input, HI_IN,LI_IN, and ENA_IN negative inputs,
and ground at UCC27288 IC
HI_IN High-side input to EVM
HI High-side input pin, HI
LI_IN Low-side input to EVM
LI Low-side input pin, LI
ENA_IN Enable input to EVM. Connect to GND to disable driver.
VHB HB pin voltage
HO LD High-side output at capacitive load
HO High-side output pin
HS High-side driver return pin. Usually connected to high-side MOSFET source.
LO LD Low-side output at capacitive load
LO Low-side output pin
3 Electrical Specifications
For the full range of recommended operating specifications and design guidelines for driving loads, see
the
UCC27288 120-V Half-Bridge Driver without Bootstrap Diode Data Sheet .
CAUTION
The UCC27288EVM is designed for low-voltage evaluation only, and is not
certified for evaluation with voltages beyond the absolute maximums listed in
the electrical specifications. Do
not evaluate high-voltage parameters with this
board.