Calibrate the ADC Device on the EVM
12
SLAU796 – July 2020
Copyright © 2020, Texas Instruments Incorporated
Setup Procedure
and
show the GUI open to the
EVM
tab and
Control
tab respectively. Tabs at the
top of the panel organize the configuration into device and EVM features with user-friendly controls and a
low-level tab for directly configuring the registers. The EVM has two configurable devices, namely the
TSW12QJ1600.
The register map for each device is provided in the device data sheet
.
1. Open the TSW12QJ1600EVM GUI.
2. Select the "OnBoard 50M Ref to ADC PLL" as the clock source.
3. Select Fs = 1000 MHz MSPS as the onboard Fs selection option from the drop-down menu.
4. Select JMODE8 for the sampling and Calibration mode.
5. Click
Program Clocks and ADC
(Note: This action overwrites any previous device register settings.)
3.10 Calibrate the ADC Device on the EVM
Figure 3-3. Configuration GUI ADC Control
