Setup
3.2
LaunchPad Hardware and Firmware Setup
If using the TSU6721EVM GUI, the MSP430 LaunchPad board must be configured properly in order to
flash the processor with the TSU6721EVM firmware. The following steps are provided to use the
TSU6721EVM in conjunction with the LaunchPad.
1. With the LaunchPad unplugged, configure the headers on the LaunchPad to be in HW UART mode by
attaching jumpers on the headers indicated by the yellow boxes in
:
Figure 2. Proper Jumper Configuration on the LaunchPad
5
SLVUA77 – May 2014
TSU6721EVM Micro-USB Switch Evaluation Module
Copyright © 2014, Texas Instruments Incorporated
