Texas Instruments TSB42AA9 (StorageLynx) EVM, Руководство пользователя, Страница: 21 / 32

5-1
Programming the TSB42AA9 (StorageLynx ) EVM
Programming the TSB42AA9 (StorageLynx )
EVM
This chapter explains how to run the StorageLynx EVM programming applica-
tion. The StorageLynx EVM programming application can only be run after the
EVM hardware and software are successfully installed. See Section 3.2 for
hardware installation instructions and Section 4.2 for software installation in-
structions.
To run the EVM programming application, do the following:
1) Execute S2LynxVC.exe.
2) Under File, select Device.
3) Choose the appropriate device from the list (can vary as the Config ROM
is altered), and choose
OK.
4) Under File, select Open.
5) Choose the appropriate .hex file or .eep file for the ATA/ATAPI device con-
nected, and select
Open.
Note:
A message that the file chosen is being processed should appear in the win-
dow.
6) Under Options, choose Program Flash or Program EEPROM.
Figure 5–1 shows an example of successfully-loaded software. The
ATA/ATAPI device is now ready for use in StorageLynx EVM switch setting
Mode 0 to run from the internal program, or in StorageLynx EVM switch setting
Mode 1 to run from the program in the Flash memory.
7) Reset StorageLynx by unplugging and replugging the 1394 cable.
Note:
The Flash memory can only be programmed in Mode 1 on the EVM, but the
serial EEPROM can be programmed in either Mode 0 or Mode 1.
Chapter 5