www.ti.com
Schematics and Bill of Materials
Figure 6. Bottom-Side Layer
4
Schematics and Bill of Materials
This section provides the TPS61165EVM-283 schematic and bill of materials. The EVM was designed and
tested assuming the input voltage is 5 V ±10%. Lower input voltages may result in the part entering
current limit and therefore not providing the regulated current in the specification table. Input voltages
greater than the drop across the sum of D2-D4 but less than the 18-V maximum does not damage the IC
but causes the IC to stop switching and regulating current. At this time, the input voltage, less the drop
across D1, is applied across D2-D4, potentially damaging the diodes.
9
SLVU224C – January 2008 – Revised February 2010
TPS61165EVM-283
Copyright © 2008–2010, Texas Instruments Incorporated
