INSTALL
D2
D1
D5
TLV2553EVM-PDK Operation
10
SBAU247A – June 2015 – Revised September 2019
Copyright © 2015–2019, Texas Instruments Incorporated
TLV2553EVM-PDK Evaluation Module
6
TLV2553EVM-PDK Operation
The following instructions are a step-by-step guide to connecting the TLV2553EVM-PDK to the computer
and evaluating the performance of the TLV2553:
1. Ensure that no SD card is installed in the SD card slot J6. The SD card is not required to boot up the
TLV2553EVM-PDK with the PHI.
2. Connect the TLV2553EVM to the PHI, and install the two screws, as indicated in
.
3. Use the USB cable provided to connect the PHI to the computer.
•
LED D5 on the PHI lights up, indicating that the PHI is powered up.
•
LEDs D1 and D2 of the PHI starts blinking to indicate that the PHI is communicating with the EVM.
The resulting LED indicators are shown in
Figure 8. EVM-PDK Hardware Setup and LED Indicators
4. Double-click on the
TLV2553 EVM.exe
file to launch the TLV2553EVM-PDK GUI software.
TheTLV2553EVM GUI software folder is shown in
.
Figure 9. Launch the EVM GUI Software