Construction guide
29
Texas Instruments Robotics System Learning Kit: The Solderless Maze Edition
SEKP164
4.1 Install 1x9 header onto the TI-RSLK Max chassis board
To add the display to the chassis board, we first need to identify the
appropriate pins at the rear of the chassis board. The board has been
labeled to help identify the right section: the Sparkfun 10168 section is
on top, followed by the Adafruit 338 and 938 sections. See Figure 2.
Figure 2. Identifying the pins for the three optional displays
Next, insert the 1x8 header into the holes for the appropriate section,
with the shorter pins pointing down into the board and the longer pins
and plastic portion resting on the top side of the board. See Figure 3.
Figure 3. Insert the 1x8 header into the pins matching your display
Now flip the chassis board over and solder these pins to the back of the
board, doing your best to keep the pins straight and the plastic portion of
the headers flush to the board (Figure 4).
Figure 4. Solder the pins to the back side of the board
