Note
The DRV841x family of devices can operate as low as 1.65 V. If the power supply is less than 3.3
V, an external 3.3 V supply is required.
• Onboard eZ-FET lite circuit for MSP debugging. The eZ-FET lite allows for programming the MCU with a
custom code via USB. No external hardware tool is required for programming. This eZ-FET lite circuit also
facilitates updating of firmware when a new version of the firmware is available.
• Graphical User Interface (GUI) to control the driver input signals (nSLEEP, AIN1, IN2, BIN1, BIN2). More
information regarding the GUI in
.
• Main signal header with tests points and shunts to easily remove the signal connections between the driver
IC and the MCU. User can connect external MCU to control the motor driver on the EVM. More details are
shown in
.
• Hardware is design so that the driver can be set to dual h-bridge and parallel h-bridge control by header
jumper settings and GUI. The different control modes are explained in
• Test points for most important signals such as the control inputs, driver output, power supplies, LDO output,
and so forth. for ease of measurement.
Introduction
4
DRV8410_DRV8411_DRV8411AEVM User's Guide
SLEU121 – FEBRUARY 2022
Copyright © 2022 Texas Instruments Incorporated
