Texas Instruments DAC5652AEVM, Руководство пользователя

Страница: 3 / 12

TSW1400
FPGA
HSDC Pro
DAC5652AEVM
CHA Transformer
CHB Transformer
Clock Source
www.ti.com
Introduction
3 SLAU773 – May 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
DAC5652AEVM User's Guide
1 Introduction
Digital inputs to the DAC can be provided with CMOS level signals up to 275 MSPS through 80-pin
headers. Doing so enables the user to provide high-speed digital data to the DAC5652A.
The analog output from the DAC is available via SMA connectors. Because of its flexible design the
analog output of the DAC5652A can be configured to drive a 50-
Ω terminated cable using a 4:1 or 1:1
impedance ratio transformer or single-ended referred to GND.
Power connections to the EVM are via banana jack sockets. Separate sockets are provided for the analog
and digital supplies.
In addition to the internal band-gap reference provided by the DAC5652A device, options are provided on
the EVM to allow external reference to be provided to the DAC.
1.1 Required Hardware and Software
The following hardware and software are required to evaluate the DAC5652A device:
• DAC5652AEVM: Main circuit board containing the DAC to be evaluated
• TSW1400EVM: Hardware that generates digital patterns for the DAC: TSW1400EVM
• HSDC pro software: Software interface that controls the TSW1400EVM. Version 4.80 or higher is
recommended:
dataconverterpro-sw
1.2 Hardware Description
Figure 1 shows the EVM setup diagram.
Figure 1. DAC5652AEVM Setup Diagram