Introduction to JESD204B Short Pattern Test
12
SLAA750 – July 2017
Copyright © 2017, Texas Instruments Incorporated
DAC38RF8x Test Modes
Figure 13. HSDC Pro Select Board Menu
Step 3.
A box pops up indicating that no firmware is connected. Click the
OK
button.
Step 4.
Switch to the
DAC
tab in the HSDC Pro application by using the tabs located at the top of the
window.
Figure 14. HSDC Pro DAC Tab
Step 5.
Open the drop-down menu in the top left corner by clicking the green arrow beside the
Select
DAC
box. Select the .ini file corresponding to the configuration of the DAC. Click
Yes
in the
window that pops up to update the firmware.
Figure 15. HSDC Pro Select .ini File Menu
Step 6.
Change the data rate at the top of the HSDC pro application to the appropriate data rate for
the previously selected configuration. The data rate is determined by taking the DAC clock
frequency and dividing it by the interpolation rate. In the bottom left corner of the HSDC Pro
application, set the tone number to 1 and tone center to 10-MHz (see
). In the
Tone
selection
drop-down menu, select
Complex
and click the
Create Tones
button. Click the
Send
