Texas Instruments CC3100 SimpleLink, Руководство пользователя

Страница: 17 / 27

www.ti.com
Connecting to the PC Using EMUBOOST
3.2 Connecting the Boards
Figure 14 shows the connection of the CC3100 BoosterPack to the EMUBOOST Board. The connectors
should be aligned carefully as it does not have polarity protection and the sFlash can be erased as a
result. The pins #1 of the connectors are marked on the board using a small triangle marking; these
should be aligned while connecting.
Figure 14. The CC3100BOOST Connected to the EMUBOOST
CAUTION
Align the pin-1 of the boards together using the triangle marking on the PCB.
An incorrect connection can destroy the boards permanently.
Ensure that none of the header pins are bent before connecting the two boards.
Jumper settings on the CC3100BOOST.
3.3 Jumper Settings on the CC3100BOOST
The following table specifies the jumpers to be installed on the CC3100BOOOST before pairing with the
EMUBOOST board.
Table 8. CC3100BOOST Jumper Settings
Jumper
No Settings Notes
1 J8 (1-2) Power the BoosterPack from the EMU BOOST. The jumper shall be placed so that it is nearer to the edge of
the PCB.
3 J6 (short) No current measurement.
4 J5 (short) OOB demo jumper.
17 SWRU371B – June 2014 – Revised January 2015 CC3100 SimpleLink™ Wi-Fi
®
and IoT Solution BoosterPack Hardware
Submit Documentation Feedback
Copyright © 2014–2015, Texas Instruments Incorporated