Texas Instruments CC3000, Руководство пользователя

Страница: 13 / 19

SWRU331-007
www.ti.com
Hardware Setup
2.4 Hardware Setup
To conduct performance tests, connect the BoosterPack EVM board to the host platform using the J9 and
J10 mating connectors or the J11 and J12 single-row headers. The J9 and J10 mating connectors must
line up as shown in
Figure 2-7 . The J11 and J12 single-row headers require the signals from the EVM
board mating connectors to be wired to the host platform.
Figure 2-7. Host PCB Mating Connector Arrangement
Table 2-7 compares the pins of the LaunchPad MSP-EXP430G2 board with the CC3000 BoosterPack
EVM board.
Table 2-7. LaunchPad to BoosterPack Pin Comparison
Pin MSP430 Port CC3000 BoosterPack
1 VCC VBAT_IN
2 P1.0 VBAT_SW_EN
3 P1.1/TX NC
4 1.2/RX NC
5 P1.3 NC
6 P1.4 NC
7 P1.5 WL_SPI_CLK
8 P2.0 NC
9 P2.1 NC
10 P2.2 NC
11 P2.3 NC
12 P2.4 NC
13 P2.5 NC
14 P1.6 WL_SPI_DOUT
15 P1.7 WL_SPI_DIN
16 T/SBWT NC
17 T/SBW NC
18 2.6/XOUT WL_SPI_CS
19 P2.7/XIN WL_SPI_IRQ
20 GND GND
13 SWRU331A – November 2012 – Revised August 2014 CC3000 BoosterPack EVM Board
Submit Documentation Feedback
Copyright © 2012–2014, Texas Instruments Incorporated