Getting Started
6
SLAU821 – October 2019
Copyright © 2019, Texas Instruments Incorporated
CAPTIVATE-EMC Getting Started Guide
4.1
Setting up the Hardware
CAPTIVATE-EMC is designed to accommodate various powering methods, including through the 20-pin
connector from CAPTIVATE-PGMR and a banana jack connector from a DC power supply.
CAUTION
Do not enable both power supplies at the same time because this can damage
the CAPTIVATE-PGMR board.
Figure 5. Hardware Setup
4.2
Running the Out-of-Box Demo
By default after power up, the CAPTIVATE-EMC development kit runs system initialization and capacitive
touch calibration. When this initialization is finished, the POWER LED illuminates, the RUN LED blinks, all
other LEDs are off, and the beeper is off. Touch a button on the CAPTIVATE-EMC panel to turn on or turn
off the indicator LED above that button. The DETECT LED illuminates and the speaker beeps when a
button is touched.
Figure 6. Out-of-Box Demonstration
