Protectors
19
SLUUBQ2C – July 2017 – Revised April 2019
Copyright © 2017–2019, Texas Instruments Incorporated
Getting Started with the BQ79606A-Q1 GUI
8
Protectors
The protector tab allows for manipulation of a separate set of voltage and temperature thresholds, which
act independent of the main ADC function. This allows for redundancy in the case of an ADC failure.
8.1
Protector Configuration and OV/UV/OT/UT Selection
Configures OT/UT/OV/UV thresholds, modes, and deglitch times.
Instructions to properly configure the Protector Tab:
1. Enable TSREF
a. Go to "Advanced Comm" tab
b. Choose "Broadcast Write" for "Command"
c. Write "106" for "Register Address (Hex)"
d. Write "10" for "Bytes to Write (Hex)"
e. Press "Send Command"
Figure 24. Enable TSREF
2. Disable OVUV and OTUT (if they are enabled) - return to "Protector" tab:
a. Use the “Read” button (a in
)
b. Uncheck “Enable OVUV” and “Enable OTUT” if they are enabled (b in
c. Use the “Write” button (c in
)