Texas Instruments BQ24150, Руководство пользователя

Страница: 2 / 14

Introduction
www.ti.com
• Test Points for Key Signals Available for Testing Purpose. Easy Probe Hook-up
• Jumpers Available. Easy to Change Connections.
1.2 General Description
The BQ24150/150A/151/151A/152 evaluation module is a complete charger module for evaluating
compact, flexible, high-efficiency, USB-friendly switch-mode charge management solution for single-cell
Li-ion and Li-polymer batteries used in a wide range of portable applications.
The BQ24150/150A/151/151A/152 integrates a synchronous PWM controller, power MOSFETs, input
current sensing, high-accuracy current and voltage regulation, and charge termination, into a small WCSP
package.
The charge parameters can be programmed through an I
2
C interface.
For details, see the appropriate data sheets ( SLUS824 , SLUS847 , SLUSA27 , and SLUS931 ).
1.3 I/O Description
Jack Description
J1
–
DC+ AC adapter or USB, positive output
J1 – DC – AC adapter or USB, negative output
J2 – BAT – Battery negative terminal, connect to DC-
J2-AUXPWR/CD Connect to AUXPWR pin or CD pin
J2-BAT+ Charger positive output, connect to CSOUT pin
J3
–
SCL I
2
C clock, connect to SCL pin
J3 – SDA I
2
C data, connect to SDA pin
J3 – DC – AC adapter or USB, negative output
J4 – STAT Status output, can be connected to STAT pin by JMP1 set to EXT (2-3)
J4 – OTG/SLRST Connect to OTG/SLRST pin
J4
–
DC
–
AC adapter or USB, negative output
1.4 Control and Key Parameters Setting
Jack Description Factory Setting
LED 1-2: Connect STAT pin to LED on EVM
JMP1 Jumper On LED (1-2)
EXT 2-3: Connect STAT pin to J4-1
HI 1-2: OTG or SLRST high (input or battery voltage)
JMP2
LO 2-3: OTG or SLRST low (ground)
See Table 1
JMP3 J2-BAT+ connect to J2-AUXPWR/CD
JMP4 AUXPWR/CD pin connect to high or low or float
JMP5 OTG/SLRST pin 10k resistor to ground or float Jumper ON
1.5 Recommended Operating Conditions
Min Typ Max Unit Notes
Supply voltage, V
IN
Input voltage from ac adapter input 4 5 6 V
Battery voltage, V
BAT
Voltage applied at VBAT terminal of J8 0 3-4.2 4.44 V
Supply current, I
AC
Maximum input current from ac adapter input 0 0.1 – 0.5 1.5 A
Charge current, I
chrg
Battery charge current 0.55 0.7 1.25 A
Operating junction temperature range, T
J
0 125 ° C
2 bq24150/150A/151/151A/152 YFF EVM (HPA256) SLUU321C – June 2008 – Revised June 2011
Submit Documentation Feedback
Copyright © 2008 – 2011, Texas Instruments Incorporated