BOOSTXL-ADS7841-Q1EVM EVM Setup
12
SNAU229 – December 2017
Copyright © 2017, Texas Instruments Incorporated
BOOSTXL-ADS7841-Q1 BoosterPack™ User's Guide
3.3
BOOSTXL-ADC7841-Q1 EVM Stack Up
Following are the instructions to set up the BOOSTXL-ADS7841-Q1EVM for evaluation:
1. Stack the BOOSTXL-ADS7841-Q1 EVM on the TM4C1294 LaunchPad™. Make sure the 20-pin
connector (J1, J3) on BOOSTXL-ADS7841-Q1 EVM is mapped against connector X6 and connector
(J4, J2) on BOOSTXL-ADS7841-Q1EVM is mapped against connector X7 on the TM4C1294
LaunchPad™. Pin 1 of BOOSTXL-ADS7841-Q1EVM must align with pin 1 of connector X6 on the
TM4C1294 LaunchPad™.
2. Position the power select JP1 jumper on the TM4C1294 LaunchPad™ on pins corresponding to OTG.
3. Connect using the micro USB cable, the TM4C1294 LaunchPad™ USB port U7 to the PC. This must
light the green power LED D0 on the TM4C1294 LaunchPad™
4. Open computer's "Device Manager". You must see under ports “VIA USB BoosterPack” and “VIA USB
BoosterPack Console” as shown in
Figure 9. TMC1294 LaunchPad™ VIA BoosterPack Driver