Basic Test Procedure
3.3
TSW1400 Quick-Start Operation
The TSW1400 is a high speed data capture and pattern generator board used to evaluate performances
of a wide range of TI high-speed analog-to-digital converters (ADC) and digital-to-analog converters
(DAC).
See the TSW1400 user’s guide (
) for a more detailed explanation of the TSW1400 setup and
operation. This document assumes that High Speed Data Pro software is installed and functioning
properly. The front panel of TSW1400 is shown in
and
. Change the following parameters
from the default settings.
Multitone Setup from Default Configuration
•
Launch the
High Speed Data Convertor Pro
software. Click
OK
on the
Select Board
pop up message.
•
Select the
DAC
tab.
•
Select
CMOS_AFE7070
from the top left drop-down menu.
•
Set the Data rate to "65" MHz and DAC Option to
Offset Bin
.
•
Set
I/Q Multitone Generator
→
Tone BW
to "1M", set
#
(of tones) to "2", and
Tone Center
to "5M".
•
Under
Tone selection
, select
Complex
.
•
Click the
Create Tones
button.
•
Click
Send
.
Figure 6. TSW1400 Programming GUI
9
SLOU337A – March 2012 – Revised July 2015
AFE707xEVM Evaluation Module
Copyright © 2012–2015, Texas Instruments Incorporated
