Texas Instruments ADS62PXXEVM, Руководство пользователя

Страница: 13 / 27

www.ti.com
Circuit Description
Table 7. EVM Clock Input Options
Jumper Changes Frequency Input CDC Configuration
EVM Option Evaluation Goal Comments
Required on J19 Description
SJP4 → 1-2
Evaluate ADC SJP7 → 1-2
ADC's Sampling
1 performance using a SJP6 → 3-4 NA Default
Frequency
sinusoid clock J14 → 1-2
J15 → No shunt
Evaluate ADC SJP4 → 2-3
performance using a SJP7 → 3-4
CDCE72010 PLL Divide VCXO frequency Maximum
2 crystal filtered LVCMOS SJP6 → 5-6
Reference Clock by 4, output on Y0 performance
clock derived from J14 → No Shunt
CDCE72010 J15 → No Shunt
SJP4
→
2-3
SJP7 → 5-6
Evaluate ADC SJP6
→
1-2 Divide VCXO frequency
Not
performance using a J14 → No Shunt CDCE72010 PLL by 4, differential
3 recommended for
differential LVPECL J15
→
No Shunt Reference Clock LVPECL Clock output
most applications
clock Install R123, R124, on Y1P and Y1N
R14, R9
Remove T6
2.2.4.1 Clock Option 1
The Clock Option 1 provides a clock to ADC directly from an external source. For the direct supply of the
clock to the ADC, a single-ended square or sinusoidal clock input must be applied to J19. The clock
frequency must be within the maximum frequency specified for the ADC. The clock input is converted to a
differential signal by a Mini-Circuits™ ADT4-1WT, which has an impedance ratio of 4, implying that
voltage applied on J19 is stepped up by a factor of 2. ADC performance in this case depends on the clock
source quality. This option is also the default configuration on the EVM, when it is shipped from the
factory. The test result using this option is shown in
Figure 9 .
2.2.4.2 Clock Option 2
Option 2 uses the onboard VCXO and CDCE72010 to provide a clock to the ADC. The CDCE72010 is
used in SPI mode which uses the internal EEPROM to configure the CDCE72010. The EEPROM is
programmed in the factory for a divide-by-4 configuration. The EEPROM configuration is shown in
Figure 3 . The clock at J19 is the reference clock for CDCE72010. The VCXO frequency can be calculated
as Fvcxo = Fout x 4 (Fout is the frequency output U0 and U1). The reference clock for CDCE72010 is
calculated from Ref Clock = (Fvcxo x 125)/(48 x 128). This is the clock-to-M divider. When VCXO of
frequency 983.04 MHz is used, the calculation results in a reference clock of 20 MHz; the clock output on
Y0 pin of CDCE72010 is 245.76 MHz. This clock is filtered using the crystal filter with center frequency of
245.76 MHz. By default, the VCXO and the crystal filter are not populated on the EVM, so that the user
can populate the components depending on the end application and sampling rate. This configuration is
recommended for applications requiring an onboard clock generation scheme. The test result using this
option is shown in
Figure 10 .
13 SLAU237B – May 2008 – Revised July 2010 ADS62PXXEVM
Copyright © 2008–2010, Texas Instruments Incorporated