Texas Instruments ADS54J40, Руководство пользователя, Страница: 5 / 21

170 MHz, +15 dBm
Low-Noise
Power Supply
5 VDC @ 3 A
Power
Switch
TSW14J56EVM
PC Running
HSDC Pro
Mini-USB Cable
170-MHz
Bandpass
Filter
USB 3.0 Cable
ADS54J40
EVM
AINP
BINP
Analog Input
Low-Noise
Signal Generator
5-VDC Power Supply Cable
Low-Noise
Power Supply
5 VDC @ 3 A
www.ti.com
Quick Start Guide
2.2 Hardware Setup Procedure
A typical test setup using the ADS54J40EVM and TSW14J56EVM is shown in Figure 2 . This is the test
setup used for the quick start procedure. The rest of this section describes the hardware setup steps.
Figure 2. Quick Start Test Setup
2.2.1 TSW14J56EVM Setup
First, setup the TSW14J56EVM using the following steps:
1. Connect the ADS54J40EVM to the TSW14J56EVM using the FMC connectors.
2. Connect the included power supply cable to connector J11 (+5V IN) and the other end to a
+5 VDC ±0.3 VDC, 3-A power supply.
3. Connect the included USB cable between the host computer and USB connector (J9).
4. Turn on the power supply. Flip the power switch (SW6) to the ON position.
5 SLAU652A – October 2015 – Revised January 2016 ADS54J40EVM
Submit Documentation Feedback
Copyright © 2015–2016, Texas Instruments Incorporated