www.ti.com
ADS1259EVM-PDK Operation
9.2
Setting Up the ADS1259EVM-PDK
The ADS1259EVM-PDK contains both the ADS1259EVM and the MMB0 motherboard; however, the
devices are shipped unconnected. Follow these steps to set up the ADS1259EVM-PDK:
Step 1.
Unpack the ADS1259EVM-PDK package.
Step 2.
Set the jumpers and switches on the MMB0 as shown in
•
Set the Boot Mode switch to USB.
•
C5V and +5VA on jumper block J13 (if +5V is supplied from J14 +5VA).
•
Leave +5V and +5VA disconnected on jumper block J13.
•
If the PDK will be powered from an ac adapter, connect J12. If the PDK will be powered
through the terminal block, disconnect J12 (see
for details on connecting the
power supply).
Figure 13. MMB0 Initial Configuration
15
SBAU163A – March 2010 – Revised April 2010
ADS1259EVM, ADS1259EVM-PDK
Copyright © 2010, Texas Instruments Incorporated
