+5VA
-
5VA
+5VD
+3.3V
+1.8V
+10V
-
10V
PWR & VREF
USB
USB
RESET
DAC1220
TUSB3410
MSP430F449
+1
-
1
DAC
IN
OUT
Analog
Daughtercard
Modular
Connectors
Power
Power from
PWR & VREF Block
Serial
Joystick
RESET
OPER
LCD DISPLAY
BSL
2.5V
Supplied to
Daughtercard
Power Connector
ADS1246EVM-PDK Kit Operation
8.2.1
About the MMB3
The MMB3 is a Modular EVM System motherboard. It is designed around the
, a low-power
microcontroller from Texas Instruments.
shows a block diagram of the MMB3.
Figure 8. MMB3 Block Diagram
The MMB3 was designed to be used as a stand-alone demonstration platform for low-speed data
converters. It features an onboard 20-bit digital-to-analog converter (DAC) that can be used as a signal
source for an ADC under test, and has a joystick for control of functions on the board when it is not
controlled by a PC. These features are experimental and not supported in the ADS1246EVM-PDK at
this time.
The MMB3 derives power from the USB interface, and gen5VD, 3.3V, and 1.8V, as well as +5VA,
–
5VA, and
±
10V. The
±
10V is supplied to the daughtercard power connector as +VA and
–
VA.
The MMB3 is not sold as a microcontroller development board, and it is not available separately. TI cannot
offer support for the MMB3 except as part of an EVM kit. For schematics or other information about the
MMB3, contact Texas Instruments.
12
ADS1146EVM, ADS1246EVM, ADS1146EVM-PDK, ADS1246EVM-PDK
SBAU149B
–
June 2009
–
Revised May 2011
Copyright
©
2009
–
2011, Texas Instruments Incorporated
