Texas Equipment Smart Combi 100, Инструкция по эксплуатации

Страница: 11 / 14

11
Identification of parts
See fig.1 illustration:
Assembly
Mount the handle as shown in Fig 2. Ensure that the machine is in balance and bolts are tighten.
Attach the middle tube to the machine, fasten with butterfly knob. See fig 2.
Attaching the:
Trimmer
B.
Attach the trimmer to the machine and fasten.
See fig 2.
Chainsaw
C. Attach the chainsaw to the middle tube and fasten. See Fig. 2.
It is recommended to lubricate the chain every 30-45 min
Hedge trimmer
D. Attach the hedge trimmer to the middle tube and fasten. See Fig. 2.
Use of attachements
Chainsaw

Do not use the saw (chainsaw) standing on a ladder or another aid in unstable position.

Beware of falling branches.
Hedge trimmer

Hedge scissors may be used not only on hedges but also to cut shrubs.

The best cutting output may be obtained when the scissors are conducted at an approximate angle of
15°to the hedge.

To obtain an even height of the hedgerow, it is recommended to have a conducting cord stretched
along the hedge.

Side surface area of the hedge will be trimmed by arched movements from down and upwards.

Clean the unit after every use and check all the integrated tools and protection devices for damages.
Trimmer

When the engine is stopped the rotating wire must be held in grass or bush until it holds still.

Always hold the machine with both hands.

The machine must not be used if the safety guard is not correctly fitted and in mint condition.

Always stop the engine before attempting to remove objects that may have stuck on the wire.

Never touch or try to stop the wire while it is still spinning.

A rotating wire may cause damage, as it continues to spin after the engine has stopped. Always be
in control of the tool until the wire has stopped spinning.

Always make sure that the wire is mounted securely and correctly before every time it is used.

Only use original spare parts.

Only use the wire for weeds, grass and similar.

Kickback is something that may occur when the rotating wire gets into contact with something, it
cannot cut. This contact may have the effect, that the wire stops for a moment, and suddenly the tool
is thrown away from the hard object that was hitting. This reaction may be so violent that the user
loses control of the tool. Kickback may occur without warning if the wire is stuck, loses speed or
impeded. This is most likely in areas where it is difficult to see the material that is being cut.

The harness must always be used and adjusted to fit in the correct manner.

Keep a firm grip on both handles while the wire is running. Keep the wire away from your body and
below your waist.
A Engine C Chainsaw
B Grass trimmer D
Hedgtrimmer
( Adjustable 135°)