6
Start and stop
How to start a cold engine
1. Place the brush cutter on a flat stabile surface.
2. Set the switch to ( I ). See il.. 6A
3. Press 8-10 times on the fuel pump under the air filter,
see ill. 6B.
4. Set the choke lever to start position, see ill.7
5. Pull the start cord out slowly from engine until resistance
is felt. Then pull strongly in start cord. Always feed the
start cord back into the engine by hand. Repeat up to 3
times until initial ignition is heard.
6. Set the choke lever to drive position, see ill. 8
7. Pull the start cord (according to point 5) until the engine
runs.
How to start a warm engine
1. Set the choke lever to drive position, see ill. 8
2. Pull the start cord until the engine runs.
How to stop the engine
1. Release the throttle button.
2. Set the switch to ( O ) position, see ill. 6A
Vibrations may travel up into the handle during
use. We therefore recommend taking a break
every 2 hours.
Operating the machine
Remove all foreign objects from the work area before
using the machine. Stones, glass, branches and similar
items may damage the machine. Also check the bolts
are tightened.
Start the motor as per the instructions below. Stand
clear of the machine’s moving parts.
Never attempt to move the machine in any way other
than intended for normal use while the motor is running.
Work from left towards right, see ill. 9.
Cleaning
The machine should be cleaned after use. Use a garden
hose to wash off soil and dirt. Remove the trimmer head from
the trimmer axel to remove wedged grass etc. from the rotor
shaft. The chassis number should only be cleaned with a
damp cloth to avoid unnecessary wear. Avoid using a high-
pressure washer during cleaning.
Storage
•
If the machine is likely to be stored unused for
prolonged periods, follow the instructions below.
This will ensure longer machine lifetime.
•
Use a garden hose to wash off soil, grass and dirt.
Remove any grass, etc. from the shaft. The chassis
number should only be cleaned with a damp cloth to
avoid unnecessary wear. Avoid using a high-
pressure washer during cleaning.
•
Wipe the machine with a damp cloth so that all
surfaces are clean. Wipe the surfaces down with an
oily cloth to prevent rust.
•
Always store the machine in a dry, clean location.
Troubleshooting
The motor will not start
1. Check the fuel control is set correctly.
2. Check the spark plug.
3. Check there is fresh gas in the tank.
The motor is not running smoothly
1. Check there is fresh gas in the tank.
The trimmer will not rotate
1. Check the cables are in good working order and
fitted correctly.
2. Check and remove wedged grass.
Noise, vibration and precautionary measures
1. Long-term exposure to noise levels exceeding 85 dB
(A) are damaging. Always use ear defenders when
the machine is being used.
2. Reduce the running speed of the motor to reduce
vibration and noise levels.
3. To reduce noise levels further, only use the machine
in an open environment.
4. Vibrations can be reduced further by holding the
handle firmly.
5. Always wear close-fitting work clothes, hard-wearing
work gloves, ear defenders and non-slip boots with
steel toecaps.
6. Take a 30-minute break every 2 working hours.
Specification
TYPE
GTU26S
Connections Flexible
drive
shaft without
clutch
Handle D-handle
Weight w/o fuel (kg)
5.5
Engine size (cc)
26
Output (KW)
0,7
Spark plug (item #)
Denso
W22MPR-U
(10011022)
Carburetor Membrane
type
Start Recoil
Fuel
Lead free 95
octane gasoline
mixed with 2
stroke oil.
Tank capacity (L)
0,6
