HOW TO USE THE MACHINE
21
electronic circuit board located under the dashboard.
Never use hose nozzles or harsh detergents to clean the
bodywork or the engine!
When washing the inside of the cutting deck and the collector channel,
the machine must be on firm ground with:
– the grass-catcher or discharge
guard fitted;
– the operator seated;
– the engine running;
– the transmission in neutral;
– the blades engaged.
Connect a water hose to each of the
pipe fittings one at a time and run water
through each one for a few minutes, with
the blades moving.
When washing, the cutting deck should be lowered right down. Take
off the grass-catcher, empty and rinse it, and then put it in a position
where it can dry quickly
5.4.10 Storage and inactivity for long periods
If you intend not to use the machine for a
long period (more than 1 month), disconnect the
battery cables and follow the instructions in the
engine instruction manual.
Empty the fuel tank by disconnecting the
tube situated at the inlet of the fuel filter and
follow the instructions in the engine manual
Carefully remove any dry grass cuttings which
may have collected around the engine or silencer to prevent their
catching fire the next time the machine is used!
Put the machine away in a dry, sheltered place and preferably
covered with a cloth.
The battery must be kept in a cool and dry place. Before a
long storage period (more than 1 month), always charge the battery, and
then recharge before using again.
The next time the machine is used, check that there are no fuel leaks
from the tubes, fuel stopcock or carburetor.
5.4.11 Card protection device
The electronic circuit board has a self-resetting protector which
breaks the circuit if there is a fault in the electrical system. It results in
the stopping of the engine and the switching off of the lamp.
The circuit automatically resets after a few seconds but the cause of
Содержание XC160-108H
Страница 4: ...INTRODUCTION 3 LABEL POSITION ...
Страница 37: ...SPECIFICATIONS 32 7 2 Machine Dimensions ...
