Texas Andreas Petersen TME 1600, Руководство пользователя, Страница: 10 / 11

10
Adjustment of cutting height
Illustration 6:
The cutting height is adjusted by the handle at the side
of the machine.
Cutting method
Illustration 8:
It will be useful to start working from at a point close to
the power supply and to work your way away from the
supply. Cut the lawn at a suitable angle from the power
supply and place the power cable to the side, which has
already been cut.
Illustration 9:
For Mulching insert the Mulching plug. As showen on
the picture.
Maintenance
Illustration 10:
Always make sure the the lawn mower is cleaned and
no grass stuck to is. Remove the grass with a bruch
every time the mower has been used. Do not use water
for this purpose.
Change the knife by loosening the bolt, replace the knife
with a new and replace the bolt.
Always check that the knife is properly fastened and in
balance after replacement.
Risk of overheating
Should the motor stop during use, it can be caused
by overheating. This product is equipped with a
thermos switch, which will stop the motor if it is being
used too hard. If that happens, let the motor cool off
for 5 minutes before starting it again.
If the machine cuts in long and wet grass or if it
continues to operate, while the collection box is full,
there is a high risk of overheating.
If the machine overheats, its thermal cutout will trip and
cause the machine to stop.
The machine will be able to be used again once it has
cooled down sufficiently.
Cooling takes up to 5 minutes.
If you frequently experience this problem, it is
recommended to increase the cutting height, push it at a
slower speed and make sure the collection box is not
full. If the grass is long and wet, the rear discharge hole
can easily be blocked even if the collection box is not
full. Therefore, check and clean often.
Specifications
Model
TME 1600
Voltage 230-240V ~ 50 Hz
Effect (Watt) 1600
Drive system push
Cutting width (cm) 38
Collector box (L) 40
Height adjustment (mm) 6 positioner 25-75
LpA 85 dB(A)
LwA
Vibrations 96 dB (A)
3,5 m/s
2
Weight (kg) 13
Warranty terms and conditions
The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Restrictions and requirements
Normal wear and replacement of wearing parts are NOT
covered by the warranty.
Wearing parts, which are NOT covered for more than 12
months:

Blades

Cables

Belts

Fuses

Switches

Membranes/gaskets
If you start the engine without adding oil, it will be
damaged and cannot be repaired and therefore not
covered by the warranty.
The warranty does NOT cover damages/faults
caused by:

Lack of service and maintenance

Structural changes

Exposure to unusual external conditions

Damages to the bodywork, deck, handles, panels
etc.

If the machine has been improperly used or
overloaded

Use of unoriginal spare parts.

Other conditions where Texas cannot be held
responsible.
Whether a case is a warranty claim or not is determined
in each case by an authorized service center.
Your receipt is your warranty note, why it should always
be kept safe.
REMEMBER: The purchase of spare parts as well as
any request for warranty repair, art. number (e.g.
900670XX), year and serial number should always be
informed. It can be found on the CE-label placed on the
deck.
* We reserve the right to change the conditions and
accept no liability for any misprints