15
Airfilter
For proper performance and durability, the air filter
should be kept clean of sawdust and debris.
1. Loosen and remove the top cover.
2. Remove the air filter out and tap it gently against a
hard surface in order to get the dust out. If the filter
is very dirty, the air filter can be separated in two
parts. Brush both parts with a soft brush.
3. Refit filter and top cover. Pay attention to that the
filter and cover is tightly fitted.
Clean the air filter every 5 hours, more often when
working in dusty areas.
Spark Plug
The spark plug is located inside the air filter.
The spark plug must be kept clean to function optimally
1. Check the spark plug as follows.
2. Turn the machines ignition switch to "stop".
3. Remove the spark plug spark plug.
4. Brush the dirt and sawdust from around the spark
plug.
5. Remove it with a spark plug wrench.
6. Check, clean or replace if necessary.
7. Install the spark plug safely and place the spark
plug cap on the spark plug.
Part number of new spark plugs: 437729
Maintenance of bar and chain
Lubrication hole.
Dismount bar and control on
Bolthole is blocked with sawdust or dirt. Lubricate with
oil / grease.
Swords
. Clean the nose wheel and running path for
dirt. Turn any sword to distribute the wear. A worn bar
can be dangerous to use and should be replaced.
Chain
. Chain should be filed regularly for best results.
1. Make sure the bar is tightened properly.
2. Use a file.
3. File all the teeth with 3-4 coats, so they are
equal.
4. It is necessary to regularly inspect the height
of the teeth if they are too high, they should be
filed with a flat file.
Maintenance intervals
Part
Action
After
Screws / Bolts
Check /
Tighten
Each Use
Air Filter
Clean /
Replace
Every 10. hours
Fuel filter
Replace
Every 20. hours
Sword / Drive
wheel
Clean Every
Need
Spark Plug
Clean / Adjust
/ Replace
Every 20. hours
Fuelhose
Check
Every 20. hours
Chain Brake
Check
Each Use
Storage
1.
Drain all fuel from tank into a container approved
for gasoline.
2.
Start the machine and let it run until all fuel is
used.
3.
Allow machine to cool
4.
Remove the spark plug
5.
Pour 1 teaspoon of 2-cycle oil into the spark plug
hole.
6.
Pull slow in recoilline 2-3 times, this distribute
the oil in the engine.
7.
Remove the spark plug safely and set spark plug
cap firmly.
8.
Store the engine in a dry place
9.
Comply with all relevant safety instructions due
to safe storage and handling of gasoline.
Technical specifications
Model
XCS4200
Cylinder
displacement
42 cc
Net power
1.6 kW (12000/min
-1
.)
Fuel
Oil mixed 40:1 (2,5%):
Unleaded Oktan 98/100
and 2-stroke oil
Tank (fuel)
280 ml
Tank (chainoli)
230 ml
Chain Lubrecation
Automatic
Anti-vibration Yes
Weight 5.5
kg
Bar
40 cm / 16”
Bar type
Art. no. 445229
Chain type
Art. no. 40-250
LWA Guarenteed
112 dB(A)
