Texas A/S Power Split 1200 VH, Руководство пользователя

Страница: 15 / 20

15
! Never let the machine run without
supervision. STOP the machine and
remove the power cord. When you
leave the machine.
! The operator cannot be under the
influence of drugs, alcohol or
medicine. Being well rested is good
for the safety.
! Do not use the machine in the areas
with gas, petrol or other fire hazardous
substances.
! Always check that the power supply is
complying with the CE approval, and
the electrical circuit is protected and
connected with ground.
! Never open the ON/OFF switch box or
any mechanical parts. Contact the
dealer or a certified electrician.
! Make sure that the cable is never in
contact with water. The power cord
must be treated carefully. Do not pull
in the power cord of the machine
when detaching from the power
source. Keep the cable away from
extreme heat, oil and sharp items.
Identification of parts
See Figure 1
A. Wedge
B. Protector rail
C. Piston head
D. Control handles
E. Hydraulic cylinder
F. Tilt / Transportation U-handle
G. On/Off power switch
H. Power outlet
I. Engine
J. Transportation wheels
K. Hydraulic oil filling
L. Back plate for splitter
Assembly
Please assemble as showed on fig. 10-11
Electric connections
Connect the main lead to a standard
electric outlet, which equals the
specification listed on the type tag/name
plate.
WARNING!
THIS APPLIANCE MUST HAVE A
GROUND CONNECTION
Interference with the electric system, can
be dangerous, always contact a qualified
electrician.
Extension leads
If an extension cable is to be used,
always make sure water proof cables are
used and that the connector is kept well
clear of any water.
Since the cable will produce a voltage
drop, that will prevent the engine from
supplying full power and reduce the
machine’s function, it is essential that the
conductors in the cable conform the
following specifications.
0-10 meters - diameter of conductor - 1,5
mm
2.
Making ready for use
Remove the log splitter from its packing
and lubricate the splitting head by its
plastic edge.
The log splitter can be adjusted in
different positions se Fig. 2
Find the angle that fits the job.
Adjusting the angle: Remove the safety
split see Fig. 3 and the bolt can be
removed. Now you can adjust in the
desired angle.
ALWAYS mount the bolt and safety split
again after adjusting the angle.