Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: MD 30275
54
Programming the device code
General
Please note down the codes which you used for the programming. This
helps to programme the URC again in case the code got lost after changing
the batteries.
You cannot programme the URC in the TV mode.
You will have to programme a four-digit device on the source keys (
STB, DVD,
VCR, AUX
) for each device that you wish to operate with the universal remote.
The labels on the keys only serve as an aid here. You can assign any key to any
device, with exception of the TV key which can only be assigned to a TV.
VCR’s: The code search for VCR's must be done while a tape is inserted.
Pre-programming
The remote control has been pre-programmed for several devices produced by
Medion. Because of this you can use certain basic functions for Medion devices
directly and without having to programme in the device code.
Entering a device code according to the code list
The codes of the respective devices must be taken from the code list
accompanying these instructions for use. Proceed as follows:
1.
Switch the relevant device on manually.
2.
Briefly press the desired source key (
STB, DVD, VCR, AUX
).
3.
Hold the
CODE
key pressed down for approx. 3 seconds, until the blue LED
remains permanently lit.
4.
Enter the four-digit code from the code list.
The blue LED will go out briefly to confirm each press of a key.
The blue LED will go out after the last digit has been entered, if the code entry
was valid. The blue LED will flash for three seconds before going out, if an invalid
code was entered.
If the device does not respond as expected, repeat the programming, or try a
different code. Please try all the codes specified for your brand. Select the code
that causes all the available commands of your remote control to respond
correctly.
If this is not successful either, then try using the search method described in the
chapter "Automatic Search"..