Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 82663
18
Command timer
The clock must be set for this timer.
You can use the command timer to program a function that is to run automatically at
a particular time within the next 24 hours. The command series can contain up to four
commands, the first command must always be the selection of a mode key.
The following keys are not available for the remaining three commands: the mode
keys, the joystick (arrows and
OK)
,
MACRO
,
SETUP
,
EXIT
.
You can create four command timers (Timer 1, Timer 2, Timer 3, Timer 4).
When the command is run this timer is automatically deleted.
Program the command timer
Example: This is how to program a command timer to control a recording on a DVD
recorder.
Keep the
SETUP
key pressed down for approx. 3 seconds,
until
CODE SETUP
appears.
Press
SETUP
briefly twice more to open
TIMER SETUP
.
Press
OK
The
SLEEPTIMER TV
menu is displayed.
Use the arrows to select
the
TIMER 1 SETUP
menu
3
.
Press
OK
" The
TIMER 1 SET
display appears.
Press
OK
The time when the command will be run appears.
The hours flash.
Use the arrows to set
the hour and confirm by pressing
OK
. The minutes flash.
Use the arrows to set
the minutes and confirm by
pressing
OK
.
The
TIMER 1
MODE?
display prompts you to enter the command.
Use the mode key to select the device on which the command
should be performed.In our example,
DVD
if the DVD recorder
was programmed on this key.
Press
OK
. You are prompted to make the first entry
TIMER 1
KEY1
. Enter the first command. In our example: Use the number
keys to select the programme. If no other input is needed,
press
OK
or
EXIT
.
The
TIMER 1 KEY2
display appears. Enter the second
command.In our example: Press the Record key. The
TIMER 1
KEY3
display appears after the second command.
In our example, press the Record key again.
The
SUCCESS
confirmation message appears along with the
bell symbol after the third command.
Lay the universal remote control down so that it is pointing towards the device and is
not obstructed.
You can cancel programming at any time by pressing
EXIT
.
3
If a command timer has already been entered, then
TIMER 2
,
3
or
4
appears here.