6
• Ultima 800 Mk II
Attaching the spikes with adjustable height
1. Screw 2 fl at spikes
햴
each onto the metal tracks
햳
.
2. Turn the speaker over and place it upside down on a
blanket or the like so as not to damage the sensitive
surface.
3. Screw the metal brackets onto the bottom of the spea-
ker case using the Allen head screws
햵
.
Once you have attached the spikes to the speaker, turn
the speaker over.
4. By adjusting the fl at spikes
햴
, you can compensate
smaller irregularities in the base.
Connecting
Danger
Danger of injury/damage!
Set up the speakers so that there is no risk of
them tipping over and the cables don’t repre-
sent a tripping hazard.
Connecting the cables
1. Turn off your amplifi er.
2. Lay the speaker cables from your amplifi er to each
speaker. These cables should be high-quality double-
wire speaker cable with marked strands. The diameter
should amount to at least 2.5 mm
2
and no more than
10 mm
2
.
3. A connector terminal with two terminal clips is loca-
ted on the back side of the speakers. Here you can
connect the speaker cables with pin plugs, suitable
furcated cable lugs or directly. We only describe the
direct connection in these instructions.
The terminal clips are each marked red (+) and black (-).
햵
햴
햳
Make sure the polarity is correct!
Connect the like-coloured terminal clips with
one another. Otherwise the sound quality will
suffer. The speaker connections of your receiver should
be similarly marked. The strands of the speaker cables
are marked with different colours or shapes.
4. Split the single wire on both ends up to approx. 30 mm
and remove approx. 10 mm of the insulation on each
single wire. Twist the single wire so that no strands are
protruding.
5. Turn the connector terminal
counterclockwise until loose.
Run the stripped cable end
into the now visible hole.
Close the terminal by tur-
ning it clockwise. The cable
has now been clamped in
place.
6. Connect both cables to the
speakers in this way.
7. Connect the speaker cables
to your amplifi er. The operating instructions of the
appliance should contain notes on this.
%DVV$OLJPHQW
91890 GB 20110808.indd 6
91890 GB 20110808.indd 6
08.08.11 14:47
08.08.11 14:47
