12
• Subwoofer T8/T10
case, reduce the subwoofer level
on your receiver.
Configuring the sound
pattern
–
With the BASS BOOST control (12),
set the low tone sound character-
istics: from maximum depth up to
enhanced kickbass.
Adjusting the receiver
and subwoofer
Most receivers have a menu with
settings for the speakers (called
“Speaker Setup” or similar). By
following our recommendations
below, you can perfectly align the
receiver and the subwoofer:
Receiver settings
If possible, use your receiver’s cali-
bration function so that it automat-
ically adjusts the levels, phase and
run times to the room. If your receiver
doesn’t provide an automatic calibra-
tion function, the following values are
recommended:
• Subwoofer to “On”.
• Crossover frequency for subwoofer
(cut-off frequency) to 80–150
Hz depending on the connected
speaker system.
Subwoofer settings
• POWER switch (9) to “AUTO”.
• SUB LEVEL control (13) and BASS
BOOST control (12) to the interme-
diate position.
• PHASE switch (11) to “0°”.
1. Perform an audio test now and
adjust the “SUB LEVEL” control
(13) until the subwoofer can be
“easily heard”. However, it must
not drone.
2. If any deep “hits” are too hard or
too soft, adjust the setting of the
BASS BOOST control (12) and/or
the PHASE switch (11).
3. Repeat these steps with different
video and audio media.
(13)
(12)
(7)
(9)
(11)
