10
• System 10 THX Ultra 2
• Split the single wire on both ends up to approximately
30 mm and remove approximately 10 mm of insulation
on each piece. Twist the single wire so that no strands
are protruding.
• Turn the connector terminal counterclockwise until
loose. Run the stripped cable into the hole that is now
visible. Turn the terminal clockwise until closed. The
cable has now been clamped into place.
• Connect all cables to the speakers in this way.
• Connect the speaker cables to your AV receiver. You
will find notes on this in the operating instructions of
the unit.
Connecting to a power supply
• Make sure that the mains switch
6
is turned off (posi-
tion “0”).
• Connect the mains connector jack
7
with a mains
socket using the mains cord
e
.
• Also plug the mains plug of your AV receiver back into
the socket.
S 10000 SW THX
®
Ultra2
TM
6
7
Содержание System 10 THX Ultra 2
Страница 15: ... System 10 THX Ultra 2 15 Notes ...
