9
SAUNA J
GB
GB DESCALE
RUNNING THE DESCALE CYCLE
- Press the ” ”button and hold for 8 seconds to start the
descale cycle .
- The reception of the command is confirmed by three
flashes of the coloured ring nut positioned around the ” ”
key . At this point, the light becomes fixed again for a
variable period of between 30 seconds and 2 minutes .
Following an interval of between 30 seconds and two
minutes, the luminous ring around the descale button will
start to blink .
The light on the ” ” button will start to flash at high
intensity and frequency (2 flashes per second) .
The need to carry out a chemical scale removal is signalled by the dial of the ”
”, button switching on a high intensity and at the same time, with the low intensity
lighting up of the dial on the
“
”
button .
In any case, it is possible to have three more sauna cycles before the sauna
system locks down; if this occurs, the scale removal signal will remain, the dial on
the
“
”
button will be switched off and the boiler tank will not be able to operate .
To activate the descale function, proceed as follows:
