Teuco HYDROSONIC, Руководство по установке

Страница: 10 / 76

GB
ELECTRICAL CONNECTIONS (tubs with whirlpool)
3
See the Installation Standards MANUAL ATTACHED .
Connect the taps to terminal S (equipotential bonding point) with
the Yellow-Green wire.
Use terminal S for the connection of any external wires that
need to be equipotentially bonded.
Connect the alarm - only if the bathroom is equipped with
an alarm system.
Before making any electrical connections, check that the
rated voltage and current of the appliance (see data plate)
are matched to the mains power supply.
PLUMBING CONNECTIONS
4
BATHTUBS WITH TAPS (Fig. a)
Connect the taps to the hot water supply ( ) and the cold water
supply ( ) (for assembly of the taps, refer to the instructions
attached).
BATHTUBS WITH COMBINED OVERFLOW AND FILLER SPOUT
(Fig. b)
Connect the hot-and-cold mix hose to the overflow filler spout.
Be certain to observe local bylaws on backflow protection.
DRAIN CONNECTION (Fig. c)
Connect the waste to the drain using the trap provided.
To ensure troublefree operation of the whirlpool system in areas
with particularly hard water, it is advisable to install a water
softener.
a
OPERATION AND WATERTIGHTNESS TEST (tubs with whirlpool)
5
Having made all the plumbing and electrical connections, proceed to test the system:
1) Clean any dirt from the tub
2) Fill the tub up to the level of the overflow
3) Start the whirlpool (see user manual), then proceed to check that there are no leaks, and no error messages displayed on the control panel.
4) Having tested the system, complete the installation of the bathtub as described below.
c
b
10
GB
Brown
Green-Yellow
Blue
Alarm
connection
Electrical
connection