TESY IRH20RC WG, Инструкции по использованию и хранению

Страница: 5 / 80

Usage and Storage Instructions
5
EN
English
INSTRUCTION MANUAL
IRH21RC CRL
Please read these instructions carefully before
using your new heater
Thank you for choosing our Indoor/Outdoor Patio
Heater.
This owner’s manual will provide you with valuable
information necessary for the proper care and
maintenance of your new product.
Please take a few moments to thoroughly read the
instructions and familiarize yourself with all the
operational aspects of your new heater.
OPERATION
Connect the power cable to a 13 amp supply that is
located in a safe, dry area.
This unit is equipped with one setting ON/OFF.
The ON/OFF switch on the heater is used to control the
power of the heater.
Our Electric Patio Heater is equipped with three heat
settings.
1.
To operate the heater on low(900W), press the
remote control on left side button.
2. To operate the heater on high(1200W), press the
remote control on right side button.
3.
Press the remote control on left and right side
button, total 2100W.
4. To operate LED light, press the remote control top
button.
Place the heater on a firm, level ceiling surface:
•
The Hook on the ceiling hanging the Patio Heater
must be able to undertake a weight 3 or 4 times
that of the Patio Heater itself.
•
Place the hook around the Ceiling Hook and clip
on any Ring of the Chain to adjust the height of the
Patio Heater to the Floor.
•
The distance between the bottom of the Patio
Heater to the Floor must be over 1.8 meters.
•
Only operate the heater when is it in the upright
position.
ceiling
floor
w
all
Although the patio heater is shower proof, do not use
when raining or in wet conditions.
Always disconnect the power cable from the electrical
supply, when the patio heater is not in use.
CARE AND MAINTENANCE
•
When disconnected from the electrical supply, clean
the outside of the patio heater with a damp cloth.
Never use corrosive or solvent cleaners or immerse
in water.
•
Any maintenance or repairs including replacing
the halogen tube should only be carried out by a
qualified electrician or by a recommended service
center.